Chapter 7 Wireless
VMG8924-B10D/B30D User’s Guide
105
The following table describes the labels in this screen.
7.7 The Others Screen
Use this screen to configure advanced wireless settings. Click Network Setting > Wireless > Others. The
screen appears as shown.
See Section 7.9.2 on page 109 for detailed definitions of the terms listed in this screen.
Figure 38 Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 25 Network Setting > Wireless > WMM
LABEL DESCRIPTION
WMM of SSID1~4 Select On to have the VMG automatically give the wireless network (SSIDx) a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi MultiMedia
Quality of Service) gives high priority to voice and video, which makes them run more smoothly.
WMM
Automatic
Power Save
Delivery(APSD)
Select this option to extend the battery life of your mobile devices (especially useful for small
devices that are running multimedia applications). The VMG goes to sleep mode to save power
when it is not transmitting data. The AP buffers the packets sent to the VMG until the VMG
"wakes up". The VMG wakes up periodically to check for incoming data.
Note: This works only if the wireless device to which the VMG is connected also
supports this feature.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 26 Network Setting > Wireless > Others
LABEL DESCRIPTION
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS (Clear
To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
This is the maximum data fragment size that can be sent. Enter a value between 256 and 2346.
Output Power Set the output power of the VMG. If there is a high density of APs in an area, decrease the
output power to reduce interference with other APs. Select one of the following: 20%, 40%,
60%, 80% or 100%.
To Next Page
Loading...
