ZyXEL Communications VMG8924-B10D - The TFTP Server Name Screen; Technical Reference; Lans, Wans and the VMG

Chapter 8 Home Networking
VMG8924-B10D/B30D User’s Guide
132
The following table describes the labels in this screen.
8.8 The TFTP Server Name Screen
Use the TFTP Server Name screen to identify a TFTP server for configuration file download using DHCP
option 66. RFC 2132 defines the option 66 open standard. DHCP option 66 supports the IP address or the
hostname of a single TFTP server.
Click Network Setting > Home Networking > TFTP Server Name to open this screen.
Figure 54 Network Setting > Home Networking > TFTP Server Name
The following table describes the labels in this screen.
8.9 Technical Reference
This section provides some technical background information about the topics covered in this chapter.
8.9.1 LANs, WANs and the VMG
The actual physical connection determines whether the VMG ports are LAN or WAN ports. There are two
separate IP networks, one inside the LAN network and the other outside the WAN network as shown
next.
Table 35 Network Setting > Home Networking > Wake on Lan
LABEL DESCRIPTION
Wake by
Address
Select Manual and enter the IP address or MAC address of the device to turn it on remotely. The
drop-down list also lists the IP addresses that can be found in the VMG’s ARP table. Select an IP
address and it will then automatically update the IP address and MAC address in the following
fields.
IP Address Enter the IPv4 IP address of the device to turn it on.
MAC Address Enter the MAC address of the device to turn it on. A MAC address consists of six hexadecimal
character pairs.
Wake up Click this to send a wake up packet to wake up the specified device.
Table 36 Network Setting > Home Networking > TFTP Server Name
LABEL DESCRIPTION
TFTP Server
Name
Enter the the IP address or the hostname of a single TFTP server.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.