VMG8924-B10D/B30D User’s Guide
268
CHAPTER 33
Remote Management
33.1 Overview
Remote management controls through which interface(s), which services can access the VMG.
Note: The VMG is managed using the Web Configurator.
33.2 The MGMT Services Screen
Use this screen to configure through which interface(s), which services can access the VMG. You can
also specify the port numbers the services must use to connect to the VMG. Click Maintenance >
Remote Management > MGMT Services to open the following screen.
Figure 156 Maintenance > Remote Management > MGMT Services
The following table describes the fields in this screen.
Table 131 Maintenance > Remote Management > MGMT Services
LABEL DESCRIPTION
WAN Interface
used for services
Select Any_WAN to have the VMG automatically activate the remote management service
when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the VMG activate the
remote management service when the selected WAN connections are up.
service This is the service you may use to access the VMG.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to the
VMG from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
VMG from all WAN connections.
To Next Page
Loading...
