Chapter 38 Firmware Upgrade
VMG8924-B10D/B30D User’s Guide
281
Figure 167 Firmware Uploading
The VMG automatically restarts in this time causing a temporary network disconnect. In some operating
systems, you may see the following icon on your desktop.
Figure 168 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, the following screen will appear. Click OK to go back to the Firmware
Upgrade screen.
Table 139 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Upgrade Firmware
Restore Default
Settings After
Firmware
Upgrade
Click the check box to have the VMG automatically reset itself after the new firmware is
uploaded.
Current
Firmware
Version
This is the present Firmware version and the date created.
File Path Type in the location of the file you wasnt to upload in this field or click Choose File to find it.
Choose File Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to two minutes.
Upgrade WWAN Package
Current
WWAN
Package
Version
This is the present WWAN Package version and the date created.
File Path Type in the location of the file you want to upload in this field or click Choose File to find it.
Choose File Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to two minutes.
To Next Page
Loading...
