ABB ACQ810 - Page 138

138 Parameters
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
10.11 Run enable Selects the source of the external run enable signal. If the
run enable signal is switched off, the drive will not start, or
coasts to stop if running.
1 = Run enable.
Note: This parameter cannot be changed while the drive is
running.
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
COMM.CW External signal required through the fieldbus Control Word
(as indicated by 02.22 FBA main cw, bit 7).
1074201122
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
10.13 Em stop off3 Selects the source of the emergency stop OFF3 signal. The
drive is stopped along the emergency stop ramp time
defined by parameter 22.12 Em stop time.
0 = OFF3 active.
Note: This parameter cannot be changed while the drive is
running.
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
10.15 Em stop off1 Selects the source of the emergency stop OFF1 signal. The
drive is stopped using the active deceleration time.
Emergency stop can also be activated through fieldbus
(02.22
FBA main cw or 02.36 EFB main cw).
0 = OFF1 active.
Note: This parameter cannot be changed while the drive is
running.
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
No. Name/Value Description FbEq