ABB ACS2000 - Chapter 10 - Troubleshooting and maintenance; 10.1 General information; 10.2 Identifying electrical equipment; 10.3 Troubleshooting

ACS2000 User manual 2UEA001270 Rev. F LOT-1 (2)
List of tables
Table GI-1 Identifying the drive frame GI-1
Table GI-2 Identifying the drive frame GI-14
Table 2-1 Current consumption during precharge and auxiliary
power supply requirement 2-20
Table 2-2 Single-phase power supply requirement 2-21
Table 2-3 Space heater power supply requirement 2-21
Table 2-4 Power fuse ratings 2-22
Table 2-5 Fan location and quantity 2-24
Table 3-1 IOEC module configuration 3-12
Table 3-2 Module identification 3-13
Table 3-3 24 V internal voltage supply 3-13
Table 3-4 Standard digital output signal allocation 3-16
Table 3-5 Standard digital input signal allocation 3-17
Table 3-6 Standard analog input signal allocation 3-18
Table 3-7 Standard analog output signal allocation 3-18
Table 3-8 Optional digital output signal allocation 3-20
Table 3-9 Optional digital input signal allocation 3-21
Table 3-10 Optional analog input signal allocation 3-22
Table 3-11 Optional analog output signal allocation 3-22
Table 3-12 Fieldbus adapters 3-23
Table 5-1 Cabinet weight 5-2
Table 6-1 Control cable requirements 6-5
Table 6-2 Hardware requirements 6-12
Table 6-3 Power fuse ratings 6-15
Table 10-1 Function of LEDs on the AMC circuit board 10-7
Table 10-2 Fieldbus adapters 10-9
Table 10-3 Filter mat identification 10-22
Table 10-4 Phase module replacement information* 10-25
Table 10-5 Phase module special tools 10-25