ABB CRB 15000 - Page 1068

For robots running RobotWare 7.6 or later, the following signals can be
observed.
xx2200000304
4 If the signals cannot be observed, choose I/O Engineering Tool from
Configuration in the Configuration group.
5 Go back to the Visual SafeMove window and write the SafeMove
configurations to the controller again.
You will observe the signals and the communication is correctly set up.
1068 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
7 Troubleshooting
7.7 Communication failure between PLC and controller
Continued