Setting the configuration to locked
When the responsible safety user has approved the validation of the configuration,
the status of the configuration should be changed to Locked on the FlexPendant.
Running the robot in auto mode with the configuration unlocked will result in a
warning message.
1 Log in as a user with the grant Lock Safety Controller Configuration.
2 In the Settings app, select the Safety Controller, and then Configuration.
3 Select the check box Locked.
Concluding steps
After the validation is concluded, turn on the the SafeMove Assistant functionality,
with the system parameter Disable SafeMove Assistant.
Product manual - CRB 15000 131
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
3 Installation and commissioning
3.6.3 The SafeMove configurator app on FlexPendant
Continued
To Next Page
Loading...
