The CRB 15000-5/0.95 can only be used with the ABB OmniCore C30 controller
with Drive system 7, and the CRB 15000-10/1.52 and CRB 15000-12/1.27 can only
be used with the ABB OmniCore C30 controller with Drive system 10.
Note
The type of drive system installed in the controller can be found on the drive
label on the controller cabinet. Always verify the drive label before connecting
the controller to the manipulator.
Controllers delivered in RobotWare versions earlier than 7.10 may not have a
Drive label attached. Then the integrator must clearly mark an observed symbol
on the controller to avoid incorrect connections.
For more information see:
• Product manual - OmniCore C30
Spare parts and equipment
ABB supplies original spare parts and equipment which have been tested and
approved for their intended use. The installation and/or use of non-original spare
parts and equipment can negatively affect the safety, function, performance, and
structural properties of the robot. ABB is not liable for damages caused by the use
of non-original spare parts and equipment.
18 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
1 Safety
1.1.1 Limitation of liability
Continued
To Next Page
Loading...
