NoteAction
xx2000001946
Cut the cable ties.2
xx2000001945
Remove the functional and protective earth cables
by removing the screw.
3
xx2000001944
Snap loose and disconnect the connectors:
• J2.DC+
• J2.DC-
• J2.CS
• J2.CP
4
xx2000002013
Disconnect the connectors from the drive board.
• D2.X1 from X1
• D2.DC+ from DC+
• D2.DC- from ground
• D2.X4 from X4
• D2.X2 from X2
• D2.X5 from X5
CAUTION
Use tweezers to unlock connectors and pull them
off.
5
Continues on next page
Product manual - CRB 15000 231
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.3.2 Replacing the axis-1 cabling
Continued
To Next Page
Loading...
