ABB CRB 15000 - Page 849

Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the CRB 15000 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Used for CRB 15000-5/0.95.
New attachment screws and
cable tie 3HAC075545-001 are
included in the delivery.
3HAC079141-001Joint unit
Required tools and equipment
NoteArticle numberEquipment
For joint units on axes 1, 2 and 3
of CRB 15000-5/0.95.
Attachment screws M4x35 (4 pcs)
are enclosed.
3HAC077788-001Lifting aid
Always use guide pins in pairs.
For joint units on axes 1, 2 and 3
of CRB 15000-5/0.95 and axis 3
of CRB 15000-10/1.52 and CRB
15000-12/1.27.
3HAC077786-001Guide pin, M4x120
For protection of drive board
during cabling installation on joint
units of CRB 15000-5/0.95.
3HAC077790-001Protection plate
HellermannTyton 110-77001 or
similar
-Cable tie gun EVO 7i
Content is defined in section
Standard toolkit on page 1087.
-Standard toolkit
Required consumables
NoteArticle numberConsumable
Isopropanol-Cleaning agent
Loctite 574-Flange sealant
-Cable ties
Cover for axis 2/3, used for CRB
15000-5/0.95.
Replace if damaged.
3HAC061327-047O-ring
Lower arm, inner cover of CRB
15000-5/0.95. 1 pcs / cover.
Replace if damaged.
3HAC061327-044O-ring
Continues on next page
Product manual - CRB 15000 849
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.6.3 Replacing the axis-2 joint unit (CRB 15000-5/0.95)
Continued