Action
Make sure that the lifting accessory used (if required) is suitable to handle the weight
of the robot as specified in: Weight, robot on page 50
5
If the robot is not installed directly, it must be stored as described in: Storage condi-
tions, robot on page 53
6
Make sure that the expected operating environment of the robot conforms to the
specifications as described in: Operating conditions, robot on page 53
7
Before taking the robot to its installation site, make sure that the site conforms to:
• Loads on foundation, robot on page 51
• Protection classes, robot on page 53
• Requirements, foundation on page 52
8
Before moving the robot, please observe the stability of the robot: Risk of tipping/sta-
bility on page 62
9
When these prerequisites are met, the robot can be taken to its installation site as
described in section: On-site installation on page 65
10
Install required equipment, if any.
• Installing the signal lamp on IRC5 robots on page 94
11
Weight, robot
The table shows the weight of the robot.
WeightRobot model
IRB 1200-5/0.9: 54 kgIRB 1200
IRB 1200-7/0.7: 52 kg
Note
The weight does not include tools and other equipment fitted on the robot.
Continues on next page
50 Product manual - IRB 1200
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
2 Installation and commissioning
2.2.4 Pre-installation procedure
Continued
To Next Page
Loading...
