Removing the robot signal exchange proxy
Note/IllustrationAction
Location of wrist strap button:
xx2000000532
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
Pull the cable ties out from the locking
holes.
2
xx1800000488
Remove the screws and lift out the robot
signal exchange proxy.
Note
Avoid colliding with the frame of the
controller.
3
Continues on next page
Product manual - OmniCore C30 175
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.5 Installing the fieldbus master and the DeviceNet harness
Continued
To Next Page
Loading...
