ABB OmniCore C30 - Page 181

Note/IllustrationAction
Press the cover plate into the cabinet,
and lift it out.
2
Screws: Torx, countersunk screw M4x10 (2
pcs)
xx1800000739
Insert the harness into the front panel
from inside of the cabinet and secure the
screws.
3
xx1900001008
Insert the cables into the clips on the
bottom of the cabinet.
4
Refitting the main computer
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C30 181
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.5 Installing the fieldbus master and the DeviceNet harness
Continued