ABB OmniCore C30 - Page 226

Info/illustrationAction
xx1700001896
Remove the screws.2
xx1700001897
Lift the left side cover slightly to make it
leave the guide holes on the upper frame.
3
Remove the left side cover.4
Removing the rear cover
Info/illustrationAction
xx1800000468
Remove the screws.1
Remove the rear cover.2
Continues on next page
226 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.1 Opening the robot controller
Continued