Removing the robot signal exchange proxy
Note/IllustrationAction
xx1800000971
Pull the cable ties out from the locking
holes.
1
xx1800000488
Remove the screws and lift out the robot
signal exchange proxy.
Note
Avoid colliding with the frame of the
controller.
2
Removing the Ethernet extension switch (option)
Note/IllustrationAction
xx1800000491
Carefully pull the side of the Ethernet
extension switch and rotate it tightly to
take it out from the bracket.
1
Removing the connected services gateway
Continues on next page
Product manual - OmniCore C30 345
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.9 Replacing the main computer
Continued
To Next Page
Loading...
