ABB OmniCore C30 - Page 361

Note/IllustrationAction
A
A
B
B
xx1800000686
xx1900000216
Attachment screwsA
SnapsB
Remove the screws and pull the power
unit out from the two snaps on the
mounting plate.
CAUTION
Only the sheet metal on the power unit
can be used for holding.
Do not touch the connectors or the filter
on the power unit.
3
Refitting the power unit
Refitting the power unit
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C30 361
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.10 Replacing the power unit
Continued