Note/IllustrationAction
xx1900001200
Remove the screws on the bracket.2
Loosen the screw and disconnect:
• SMB - K6.X4, K6.X5
3
Removing the incoming mains connector
Note/IllustrationAction
Disconnect:
• Q0 - A1.X1.
• Two ground cables which con-
nects to the left cabinet frame.
1
xx1800000733
Remove the attachment screws on the
front panel.
2
Push the incoming mains connector into
the cabinet.
3
Take the incoming mains connector out
from the left side.
4
Refitting the incoming mains connector
Refitting the incoming mains connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
436 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the incoming mains connector
Continued
To Next Page
Loading...
