Note/IllustrationAction
Location of wrist strap button:
xx1800000683
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
2
Insert the process connectors into the
front panel from inside the cabinet.
3
Screws: Torx, countersunk screw M4x10 (2
pcs)
xx1800000739
Secure it with the screws.4
xx1900001008
Insert the cables on process connectors
into the clips in the bottom of the cabinet.
Tip
Use the same position as from removing
process connectors.
5
Continues on next page
Product manual - OmniCore C30 463
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.5 Replacing the process connectors
Continued
To Next Page
Loading...
