Note/IllustrationAction
xx1800000727
Remove the attachment screws on the
cover.
2
Push the CFI connector into the cabinet.3
Take the harness CFI connection out
from the upper side.
4
Refitting the harness CFI connection
Refitting the harness CFI connection
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
2
Insert the harness CFI connection into
the front panel from inner side of the
cabinet.
3
Continues on next page
Product manual - OmniCore C30 473
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.6 Replacing the harness CFI connection
Continued
To Next Page
Loading...
