Info/illustrationAction
xx1800000459
Torx countersunk screw M3x6 (6 pcs)
Tightening torque: 0.6-0.8 Nm
Place the controller upright and install the
right and left cover unit. Lock them with
screws on the bottom side and connect the
cables.
• K2.X15.3
• K2.X15.4
• X4
Note
Do not hold the TPU connector (X4)
during any moving or transporting of
the controller.
• MGMT
4
xx1800000460
xx1800000461
Keep the controller upright. Connect the
adapter cables to the front cover unit, and
install the front cover unit.
5
The antenna can be placed on top of the
controller.
Connect the antenna for Connected Services
Gateway (3G or WiFi).
6
Continues on next page
Product manual - OmniCore C30 73
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.5 Mounting the controller with desktop mounting kit [3001-2]
Continued
To Next Page
Loading...
