The Connected Services Gateway unit has an antenna connector on the front. See
installation procedures in section On-site installation on page 58.
xx2300000668
Customer cable layout
The antenna should go through the cable grommet and fasten on the cabinet.
Note
The end user needs to install proper grommets according to the diameter of the
cables which need to go through the grommet.
Incorrect use of grommets will affect ingress protection, EMI/EMC and
temperature.
It is recommended to use icotek KT grommet.
Ethernet outlet connector, MGMT (Management)
The following type of Ethernet cable is recommended for connection to the Ethernet
outlet connector (MGMT port):
ValueEthernet cable
75 mMaximum length
CAT5e SF/UTPType of cable
Continues on next page
104 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.9 Descriptions for connectors
Continued
To Next Page
Loading...
