ABB OmniCore V250XT Type B - Replacing the Additional Drive Unit

5.2.14 Replacing the additional drive unit
Location
The illustration shows the location of the additional drive unit in the controller.
xx2200001056
WARNING
Do not touch the drive unit when the DC-BUS High Voltage LED is on.
There is residual voltage in the drive unit even if the main switch is in the OFF
position.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT Type B via myABB Business Portal,
www.abb.com/myABB.
Continues on next page
Product manual - OmniCore V250XT Type B 267
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.14 Replacing the additional drive unit