7.2.6 Problem using the joystick
Description
The FlexPendant is started and responds when you push the buttons or tap on the
touchscreen. However, the joystick does not work and no warnings or messages
show up. It is therefore not possible to jog the robot.
Recommended working procedure
InformationAction
See Operating manual - OmniCore.Make sure that the joystick lock is not activated.1
Make sure the controller is in manual mode.2
Make sure the FlexPendant is connected cor-
rectly to the controller.
3
If the joystick is still not working, then
replace the FlexPendant.
Press the reset button located next to the USB
port on the back of the FlexPendant.
Note
The reset button only resets the FlexPendant,
not the system on the controller.
4
362 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
7 Troubleshooting
7.2.6 Problem using the joystick
To Next Page
Loading...
