3.4.3 Mounting the FlexPendant holder
Note
To avoid dropping the FlexPendant from height, the holder should be placed in
a comfortable working height.
Always use and store the FlexPendant in such a way that the cable does not
become a tripping hazard.
When not using the device, place it so it does not accidentally fall.
Required equipment
NoteSpare part numberEquipment
See Standard toolkit for con-
troller on page 426.
Standard toolkit
3HAC079391-001TPU Holder asm
Note
The FlexPendant should always be placed in the holder when it is not used and
it is not allowed to use by unauthorized person.
Mounting the bracket for the emergency stop on the FlexPendant holder
The FlexPendant holder is shipped without the bracket for the emergency stop
assembled to the holder. They are separated as two parts.
xx2100000767
Continues on next page
Product manual - OmniCore V250XT Type B 61
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the FlexPendant holder
To Next Page
Loading...
Need help?
General