ABB OmniCore V250XT Type B - Cleaning of the Controller Cabinet

4.3.2 Cleaning of the controller cabinet
Required equipment
NoteEquipment, etc.
ESD protectedVacuum cleaner
Cleaning considerations
This section specifies some special considerations when cleaning the controller.
• Always use ESD protection.
• Always use cleaning equipment as specified above. Any other cleaning
equipment may shorten the life of paint work, rust inhibitors, signs, or labels.
• Always make sure that all protective covers are fitted to the controller before
cleaning.
• Never remove any covers or other protective devices when cleaning the
outside of the controller.
• Never use compressed air or spray with a high pressure cleaner.
• Never leave the door open when cleaning the exterior.
166 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
4 Maintenance
4.3.2 Cleaning of the controller cabinet