ABB OmniCore V250XT Type B - Replacing the HMI Signal (Flexpendant) Connector

5.3.3 Replacing the HMI signal (FlexPendant) connector
Location
The illustration shows the location of the HMI signal connector in the controller.
xx2100000829
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT Type B via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Harness-TPU3HAC071006-001Harness TPU connection
Continues on next page
Product manual - OmniCore V250XT Type B 297
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector