ABB OmniCore V250XT Type B - Securing and Stacking the Controller Cabinet

3.4.2 Securing and stacking the controller cabinet
Securing the controller
The controller can be secured to the ground. The figure below shows the bolt
pattern for the OmniCore V250XT Type B controller. The diameter of the four bolt
holes are 14 mm.
xx2200001823
Stacking the controller
The OmniCore V250XT Type B controller is designed so that a maximum of two
controllers can be stacked. The controllers must be safely fixed to each other, and
it must be assured that the opened door on the upper controller does not cause
imbalance.
CAUTION
The stacked cabinets must be secured to the floor accordingly.
Note
For lifting restrictions regarding stacked cabinets, see Lifting the controller cabinet
on page 55.
60 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Securing and stacking the controller cabinet