ABB OmniCore V250XT Type B - Replacing the Safety Digital Base Device

5.2.7 Replacing the safety digital base device
Location
The illustration shows the location of the safety digital base device in the controller.
xx2300001819
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT Type B via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
DSQC10423HAC062908-001DSQC1042 Extended safety
3HAC069538-001Connectors Safety I/O
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 426.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT, rev 04 or later
Continues on next page
Product manual - OmniCore V250XT Type B 229
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.7 Replacing the safety digital base device