7.2 Troubleshooting fault symptoms
Fault symptoms described in this manual
This manual describes how to troubleshoot the following fault symptoms:
• No LEDs are lit on the controller on page 348
• Start-up failure on page 351
• Problem releasing the robot brakes on page 355
• Problem starting or connecting the FlexPendant on page 358
• Problem using the joystick on page 362
• Controller fails to start on page 363
• Reflashing firmware failure on page 364
• Inconsistent path accuracy on page 365
• Controller is overheated on page 367
Continues on next page
Product manual - OmniCore V250XT Type B 347
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
7 Troubleshooting
7.2 Troubleshooting fault symptoms
To Next Page
Loading...
