Conveyor tracking module (option)
For detail information on customer connections to conveyor tracking module, see
Application manual - Conveyor tracking, 3HAC066561-001.
xx2100002526
Customer cable layout
It is recommended to use multicore cable for the customer connection.
The cables connected by customer to the conveyor tracking module should go
through the cable grommet and fasten on the cabinet.
Note
The end user needs to install proper grommets according to the diameter of the
cables which need to go through the grommet.
Incorrect use of grommets will affect ingress protection, EMI/EMC and
temperature.
It is recommended to use icotek KT grommet.
The cable layout is recommended as the following illustration.
24V terminal block (option)
This connector is internally connected with the optional power supply. It is a 24 V
power supply for the customer. The characteristics are shown in the following
table.
ValueParameter
24 V DCVoltage
Continues on next page
106 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.9 Descriptions for connectors
Continued
To Next Page
Loading...
