Installing the additional drive unit
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2200001817
Screws: Torx pan head screw M4x8 (4 pcs)Fit the additional drive unit and secure
with the screws.
3
Tightening torque: 2 Nm
xx2200001375
Connect:
• T4.X7 -X12, T4.X15
• T4.X17 - A1.X2
• T4.X13 - A1.X11
• T4.X5 - A1.X4
• T4.X3 - A1.X12
• T4.X1 - A1.X5
4
Continues on next page
Product manual - OmniCore V250XT Type B 129
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.4 Installing additional drive units
Continued
To Next Page
Loading...
