Removing the drive unit
Note/IllustrationAction
Pull the cable ties out from the locking
holes.
Tip
Take photos of the cable ties and locking
holes before pulling out, to have as a
reference when refitting the cable ties.
1
Disconnect all connectors from the unit
to be replaced.
2
Lengthened screwdriverRemove the screws and pull the drive
unit out from the two guiding pins on the
mounting plate.
CAUTION
The cabling is sensitive to mechanical
damage. Handle it with care to avoid
damage to the cabling or the connector,
avoid any kind of tilt or skew.
3
xx2200001375
Refitting the additional drive unit
Refitting the additional drive unit
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Continues on next page
Product manual - OmniCore V250XT Type B 269
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.14 Replacing the additional drive unit
Continued
To Next Page
Loading...
