Note/IllustrationAction
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2200001817
Screws: Torx, countersunk screw M4x10 (4
pcs)
Insert the motor connector into the front
panel from inner side of the cabinet and
fasten it with the screws.
3
Tightening torque: 2.7 Nm±10%.
xx2200001982
Reconnect any connectors disconnected
at removal.
4
Secure the motor connector cables with
the velcro on the frame of the cabinet.
Tip
Use the same position as from removing
the motor connector.
5
Continues on next page
Product manual - OmniCore V250XT Type B 295
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.3.2.1 Replacing the motor connector
Continued
To Next Page
Loading...
