Removing the HMI signal connector
Note/IllustrationAction
Cut the cable ties and remove the cables
out from the clips in the cabinet carefully.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
1
Disconnect all connectors from the unit
to be replaced.
2
xx2100000830
Remove the screws.3
xx2100000831
Remove the cover plate.4
Continues on next page
Product manual - OmniCore V250XT Type B 299
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector
Continued
To Next Page
Loading...
