ABB OmniCore V250XT Type B - Page 305

Removing the cable grommet assembly
Note/IllustrationAction
Remove the cables out from the clips in
the cabinet carefully.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
1
xx2100000845
Remove the attachment screws on the
cover.
2
Push the cable grommet assembly into
the cabinet.
3
Take the cable grommet assembly out.4
Releasing the cables from the cable grommet assembly
Note/IllustrationAction
xx1900002332
Unscrew the cable entry frame from the
enclosure wall.
1
Continues on next page
Product manual - OmniCore V250XT Type B 305
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.3.4 Replacing the cable grommet assembly
Continued