Refitting the cable grommet assembly
Refitting the cables to the cable grommet assembly
Note/IllustrationAction
xx1900002337
Insert and equip the cable to the corres-
ponding KT grommet.
1
xx1900002336
Slide the grommets into the frame halves.
Note
It must be ensured that the flat side of
the grommets in the lower row are point-
ing to the open side of the frame half (flat
sides pointing upwards).
Note
The fl at side of the grommets in the up-
per row have to point downwards so that
all flat sides rest on each other. When
using single row frames the fl at side has
to point towards the cover strip.
2
xx1900002335
Refit the cover strip onto the frame.3
Continues on next page
308 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.3.4 Replacing the cable grommet assembly
Continued
To Next Page
Loading...
