ABB OmniCore V250XT Type B - Page 327

Removing the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
1
Disconnect the FlexPendant from the
controller.
2
xx1800001198
Remove the attachment screws.3
xx1800001199
Remove the joystick protection.4
Refitting the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
1
Continues on next page
Product manual - OmniCore V250XT Type B 327
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.4.2 Replacing the joystick protection
Continued