Troubleshooting the unit by connecting a PC
1 Connect a PC to the port ETH 1.
2 Configure the PC Address with IP 192.168.125.100\24 (Mask 255.255.255.0).
3 Open a browser with https://192.168.125.85/.
4 The INSYS login page is displayed:
xx2300000638
Note
Enter the following to access this page:
User (status)
Password (status)
Continues on next page
408 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
7 Troubleshooting
7.3.9 Troubleshooting the 4G Connected Services gateway
Continued
To Next Page
Loading...
