ABB OmniCore V250XT Type B - Page 83

Procedure
Use the following procedure to fit the connectors.
Note/illustrationAction
Cut the cable to desired length.1
2
1
3
4
4
PE1
3
PE2
1
2
xx2100001258
Description
L11
L22
L33
Not used4
Protective earthPE1
Protective earthPE2
Connect the wires according to the illus-
tration.
2
Tighten the screws to secure the cables.3
Remove screw and washer on top of
contact and insert the ground cable with
cable lug. Secure with washer and
screws.
4
Product manual - OmniCore V250XT Type B 83
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.5 Fitting the connector for incoming mains
Continued