Location of incoming mains connection
xx2200001755
Connection of protective earth
There are two options to connect the cabinet to protective earth:
• PE0 on front panel.
• PE1 and PE2 on X0 (incoming mains connector).
xx2200001756
Note
All connections between the cabinet and protective earth must comply with the
local electrical requirements.
Required equipment
NoteEquipment
L1, L2, L3, PE1, PE2Main connection cable (three-phase)
Details see Fitting the connector
for incoming mains on page 82.
Continues on next page
Product manual - OmniCore V250XT Type B 85
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.6 Connecting incoming mains and protective earth to the controller
Continued
To Next Page
Loading...
