PosNo Description Quantity Type
1a, 1b Mounting angles, can be mounted
either to the left or the right side of
the case
2
-
2 Screw 8 M4x6
3 Washer 8 M4x6
20.4.3 Wall mounting
IP10316-1 v1
20.4.3.1 Overview
M11973-3 v6
The IED can be mounted on a wall, a panel or in a cubicle.
Use only the screws included in the mounting kit when mounting
the plates and the angles on the IED. Screws with wrong dimension
may damage the PCBs inside the IED.
If fiber cables are bent too much, the signal can be weakened. Wall
mounting is therefore not recommended for any communication
modules with fiber connection.
Section 20 1MRK 506 382-UEN A
IED hardware
874 Line distance protection REL650 2.2 IEC
Technical manual
To Next Page
Loading...
