Appendix A
Default Parameters
F1 = QUICK
EMULATION = WYSE 50+ EIA BAUD RATE = 19200 EIA DATA FORMAT = 8\1\N
COMM MODE = FULL DUPLEX AUX BAUD RATE = 19200 AUX DATA FORMAT = 8\1\N
ENHANCED = OFF LANGUAGE = US SESSION = ONE
HOST\PRINTER = EIA/PARA or
EIA/AUX
F2 = GENERAL
EMULATION = WYSE 50+ ENHANCED = OFF AUTO WRAP = ON
AUTOFRONT LOAD = ON AUTO PAGE = OFF CURS DIR = LEFT TO RIGHT
AUTOSCROLL = ON MONITOR MODE = OFF SCREEN SAVER = 5 MIN
BELL VOLUME = 09 WARNING BELL = ON BELL LENGTH = 350 ms
HOST\PRINTER = EIA\PAR SETUP LANG = US SESSIONS = ONE
F3 = DISPLAY
PAGE LENGTH = 24 SCREEN LENGTH = 26 SCREEN VIDEO = NORMAL
DISPLAY CURSOR = ON CURSOR = BLINK BLOCK AUTO ADJUST CURSOR = ON
COLUMNS = WIDTH CHANGE CLR = OFF SPEED = FAST
SCROLL = JUMP REFRESH RATE = 100 HZ
F4 = KYBD
LANGUAGE = US KEY MODE = ASCII KEYCLICK = OFF
KEY REPEAT = ON KEY RATE = 20 CPS MARGIN BELL = OFF
KEY LOCKS = CAPS CAPS LOCK = TOGGLE NUM LOCK = TOGGLE
F5 = KEYS
ENTER KEY = <CR> RETURN KEY = <CR> BACKSPACE = <BS>/<DEL>
ALT KEY = ALT KEY DISCONNECT = PAUSE DESK ACC = CTRL <----
POUND KEY = U.S. RETURN KEY REPEAT = OFF UDKS = EMUL DEPENDENT
F6 = PORTS
EIA BAUD RATE = 19200 EIA DATA FORMAT = 8\1\N EIA PARITY CHECK = OFF
AUX BAUD RATE = 19200 AUX DATA FORMAT = 8\1\N AUX PARITY CHECK = OFF
EIA XMT = BOTH EIA RECV = XANY-XOFF (XPC) EIA XMT PACE = BAUD
AUX XMT = BOTH AUX RECV = XANY-XOFF (XPC) AUX XMT PACE = BAUD
EIA BREAK = 250 ms EIA MODEM CONTROL = OFF EIA DISCONNECT = 2 SEC
AUX BREAK = 250 ms AUX MODEM CONTROL = OFF AUX DISCONNECT = 2 SEC
F7 = HOST
COMM MODE = FULL DUPLEX LOCAL = OFF RECV <CR> = <CR>
RECV <DEL> = IGNORE SEND ACK = OFF SEND LINE TERM = US
SEND BLOCK TERM = <CR> NULL SUPPRESS = OFF ALT INPUT DATA = OFF
F8 = PRINT
PRINT LINE TERM = <US> PRINT BLOCK TERM = <CR> SECONDARY RECV = ON
F9 = EMUL
BRIGHT VIDEO = OFF PAGE EDIT = OFF WPRT INTENSITY = DIM
WPRT REVERSE = OFF WPRT UNDERLINE = OFF WPRT BLINK = OFF
DISPLAY NV LABELS = OFF SAVE LABELS = ON STATUS LINE = STANDARD
FKEY SPEED = NORMAL WP-GRAPHICS = ON
F10 = TABS
AUTO INIT TABS = OFF DEFAULT TABS = DEFAULT
F11 = ANSBK
ANSWERBACK MODE = OFF REST ARE DEFAULTS
F12 = PROG (FUNCTION KEYS)
ALL DEFAULTS or PROGRAM AS NEEDED (see Function Key Setup)
366 Dimensions 14
To Next Page
Loading...