Appendix A
WYSE 150
Set Up Mode
At any point during normal operations (i.e., PASSWORD screen, system
prompt, menu, program), you can enter the set up mode for the terminal. To
do this, hold down the Shift key and press Set Up.
There are 8 sets of values obtained by pressing the function keys F1 through
F7 and F11. Use the arrow keys to select a field. Press the Space Bar to
display the next selection for a field or Esc to call the default response. See
the default parameters below. Parameters shown in bold type can be either
response.
After making changes to the set up values, press F12 (function key 12).
Press the Space Bar to answer yes to save the changes, then press F12
again to exit.
Default Parameters
F1
COLUMNS = 80 CURSOR = BLINK BLOCK SCRN SAVER = SCRN ON
LINES = 24 DISPLAY = DARK CHAR CELL = 10 X 16
PAGE = 1 X LINES AUTOPAGE = OFF 80/132 CLR = ON
F2
PERSONALITY = WYSE 50+ ENHANCE = OFF STATUS LINE = ON
SCRL = JUMP AUTO SCRL = ON WRAP EOL = ON
RCV CR = CR MONITOR = OFF RECOGNIZE DEL = OFF
F3
KEYCLICK = ON REPEAT = ON KEYCODE = ASCII
KEYLOCK = CAPS MARGIN BELL = OFF BELL VOLUME = 1
LANGUAGE = US CORNER KEY = FUNCT
F4
BAUD RATE = 19200/9600 DATA/PARITY = 8/NONE STOP BITS = 1
RCV HNDSHK = BOTH RCV HNDSHK LEVEL = 192 XMIT HNDSHK = XON/XOFF
COMM = FDX XMIT LIMIT = NONE HOST PORT = SERIAL 1
F5
WPRT INTENSITY = DIM WPRT REV = OFF WPRT UNDRLN = OFF
BLK END = US/CR ATTRIBUTE = CHAR MULTIPLE PAGE = OFF
PRINTER ATTACHED = ON NULLS SUPRESS = ON
F6
CHAR SET = MULTINAT CHAR MODE = MULTINAT ANSI ID = VT 100
CURSOR KEYS = NORMAL KEYPAD = NUMERIC DEL = DEL/CAN
FEATURE LOCK = OFF FKEY LOCK = OFF NEWLINE = OFF
F7
PRINT = ASCII PRINT AREA = SCREEN PRINT TERM = NONE
SEND = ALL SEND AREA = SCREEN SEND TERM = NONE
XFER TERM = EOS AUTO ANSWERBACK = OFF KEYS = TYPEWRITER
F11
BAUD RATE = 19200/9600 DATA/PARITY = 8/NONE STOP BITS = 2/1
PRINTER = SERIAL (unless otherwise specified to be parallel)
374 Dimensions 14
To Next Page
Loading...