Appendix A
WYSE 60
Set Up Mode
At any point during normal operations (i.e., PASSWORD screen, system
prompt, menu, program), you can enter the set up mode for the terminal. To
do this, hold down the Shift key and press Set Up.
There are 8 sets of values obtained by pressing the function keys F1 through
F8. Use the arrow keys to select a field. Press the Space Bar to display the
next selection for a field or Esc to call the default response. See the default
parameters below. Parameters shown in bold type can be either response.
After making changes to the set up values, press F12 (function key 12).
Press the Space Bar to answer yes to save the changes, then press F12
again to exit.
Default Parameters
F1
COLUMNS = 80 STATUS = ON STANDARD BACKGROUND = DARK
LINES = 24 SCRL SPEED = JUMP SCREENSAVER = ON
PAGE = 1 X LINES CURSOR = BLINK BLK DISPLAY CURSOR = ON
ATTR = CHAR ANSWERBACK = OFF ANSWER CONCL = ON
F2
PERSONALITY = WYSE 50+ ENHANCE = OFF FONT LOAD = OFF
COMM MODE = FL DPLX EOL WRAP = ON SEND ACK = OFF
DATA/PRT = MODEM/AUX AUTO SCRL = ON INIT TAB = OFF
RCV CR = CR MONITOR = OFF WIDTH CHG - OFF
F3
KEYCLICK = ON/OFF KEYLOCK = CAPS KEY REPEAT = ON
RETURN = CR ENTER = CR CORNER KEY = FUNCTION
XMIT LIMIT = NONE FKEY LIMIT = NONE BREAK = 250ms
WYSEWORD = OFF LANGUAGE = US MARGIN BELL = OFF
F4
BAUD RATE = 19200/9600 DATA/STOP = 8/1 - 7/1 PARITY = NONE
RCV HSK = BOTH XMIT HSK = NONE XPC HSK = OFF
AUX BAUD = 19200/9600 AUX DATA/STOP = 8/1 AUX PARITY = NONE
AUX RCV HSK = BOTH AUX XMIT HSK = XON/XOFF
F5
BLOCK END = US/CR LABELS = OFF WPRT INTENSITY = DIM
AUTO PAGE = OFF SAVE LABELS = OFF WPRT REVERSE = OFF
TVI955 = NO SPACE PAGE EDIT = OFF WPRT UNDERLINE = OFF
VP 60 BLK END = NONE TEST = OFF
372 Dimensions 14
To Next Page
Loading...