Appendix D
BASIC & SuperDOS Errors
BASIC and SuperDOS errors occur when the information used by the
program cannot be processed by the operating system. These errors typically
occur in reading and writing to a disk drive.
ERR BASIC SD # CAUSE COMMENTS
ERR BASIC –23 SD 3 Not enough disk space Delete any .SV* files. Run
CRUNCH if necessary.
ERR BASIC -48 SD 5 File being used exclusively Wait to run your program or job
later.
ERR BASIC -135 SD 8 Bad “deleted” record Rebuild indexes of file. This error
is usually seen if system was
shut down while users were in
programs.
ERR BASIC -137 SD 10 Attempt to access sector The indexes of the file need to be
beyond file deleted and then rebuilt.
ERR BASIC -142 SD 15 No available records File needs to be expanded.
ERR BASIC –149 SD 22 Read error file data record This message can indicate a
possible hardware problem. Call
Dimensions support.
ERR BASIC -150 SD 23 File not found Call Dimensions support.
ERR BASIC -163 SD 36 Bad FCB validation code Indicates an error in a file. Call
Dimensions support.
ERR BASIC -165 SD 38 Invalid user group Signed on under the wrong
password.
ERR BASIC –167 SD 40 Error in absolute sector I/O Dirty floppy drive, bad floppy
diskette, or possible hard drive
problem.
ERR BASIC -78 SD 52 Not an executable program Bad version of a program.
ERR BASIC -78 SD 58 Disk CRC error Bad sectors on disk drive.
ERR BASIC -31 SD 10 Invalid subscript File contains bad information.
Indexes need to be rebuilt.
ERR BASIC 23 No more data memory left Task size too small to run
program.
ERR BASIC 16 SD 10 Divide by zero A transaction or item has a bad
cost so margins can’t be
calculated.
For additional BASIC and SuperDOS errors, refer to SuperDOS Guide to
Operations.
Dimensions 14 463
To Next Page
Loading...