Appendix A
WYSE 55
Set Up Mode
At any point during normal operations (i.e., PASSWORD screen, system
prompt, menu, program), you can enter the set up mode for the terminal. To
do this, hold down the Shift key and press Set Up.
There are 8 sets of values obtained by pressing the function keys F1 through
F8. Use the arrow keys to select a field. Press the Space Bar to display the
next selection for a field or Esc to call the default response. See the default
parameters below. Parameters shown in bold type can be either response.
After making changes to the set up values, press F12 (function key 12).
Press the Space Bar to answer All to save the changes, then press F12
again to exit.
Default Parameters
F1
COLUMNS = 80 CURSOR = BLINK BLOCK SCRN SAVER = SCRN ON
LINES = 24 DISPLAY = DARK CHAR CELL = 10 x 15
PAGE = 1 X LINES AUTOPAGE = OFF 80/132 CLR = ON
F2
PERSONALITY = WYSE 50+ ENHANCE = OFF STATUS LINE = ON
SCRL = JUMP AUTO SCRL = ON WRAP EOL = ON
RCV CR = CR MONITOR = OFF RECOGNIZE DEL = OFF
F3
KEYCLICK = ON/OFF REPEAT = ON KEYCODE = ASCII
KEYLOCK = CAPS MARGIN BELL = OFF BELL VOLUME = 1
LANGUAGE = US CORNER KEY = FUNCT
F4
COMM = FDX XMIT LIMIT = NONE ANSWERBACK MODE = OFF
MDM HNDSHK = BOTH RCV RC HSK LELVEL = 192 MDM XMIT HSK = XON/XOFF
AUX RC HSK = XON/XOFF SEND ACK = ON AUX XMT HSK = XON/XOFF
F5
MDM BAUD RATE = 19200/9600 MDM DATA/PARITY = 8/7 / NONE MDM STOP BITS = 1
AUX BAUD RATE = 19200/9600 AUX DATA/PARITY = 8/NONE AUX STOP BITS = 1
HOST PORT = MODEM PORT
F6
WPRT INTENSITY = DIM WPRT REV = OFF WPRT UNDRLN = OFF
BLK END = US/CR ATTRIBUTE = PAGE -DFLT MULTIPLE PAGE = OFF
PRINTER ATTACHED = ON NULLS SUPPRESS = ON REST/ACT. TIMES = NONE
F7
CHAR SET = MULTINAT CHAR MODE = MULTINAT ANSI ID = VT 100
CURSOR KEYS = NORMAL KEYPAD = NUMERIC DEL = DEL/CAN
FEATURE LOCK = OFF FKEY LOCK = OFF NEWLINE = OFF
F8
PRINT = ASCII PRINT AREA = PAGE PRINT TERM = NONE
SEND = ALL SEND AREA = PAGE SEND TERM = NONE
XFER TERM = EOS AUTO ANSWERBACK = OFF KEYS = TYPEWRITER
370 Dimensions 14
To Next Page
Loading...