Appendix A
4 Enter the appropriate data that you obtained above. Use the following table
for special characters:
To enter:
Hold down the Ctrl key and press:
Enter / <CR> M
Esc [ (left bracket)
Tab I
Up arrow ()
K
You are limited to a maximum of 64 characters for all function keys
combined.
5 Check your entries. If you need to make corrections, press the function key
you are programming and re-enter the data. Check your entry again!
6 When you are entered the data for this key, press Enter.
7 If you want to program another function key, press the function key you want
to set up. Enter the appropriate data. If you do not wish to set up more
function keys, press Shift and Set Up.
8 Enter A to save the function keys. The terminal will take a few seconds to
adjust its memory and then returns to the original program.
9 Go to the play company and test your new function key settings before using
them in your live data.
Dimensions 14 369
To Next Page
Loading...