Appendix A
OKIDATA 320/321
Menu Selection
With the printer’s “Menu Select” mode, you can print a list or “menu” of
features available and then select the ones you want to change using the
printer’s control panel buttons. These features remain selected even if you
turn your printer off.
Function: Action:
Enter Menu Select mode Press MODE button.
Print current menu Press PRINT button.
Move to next option Press GROUP button.
Move to previous option Press ITEM button.
Change a selection Press SET button.
Exit Menu Select mode Press MODE button.
Standard Printer Settings (Okidata emulation)
Parameters shown in bold type can be either response.
Font Print Mode UTILITY
Pitch 10 CPI
Proportional Spacing NO
Style NORMAL
Size SINGLE
General Control Graphics BI-DIRECTIONAL
7 or 8 Bit Graphics 8
Max Receive Buffer FULL
Paper Out Override NO
Print Registration 0
7 or 8 Bit Data Word 8
Operator Panel Functions FULL OPERATION
Reset Inhibit NO
Print Suppress Effective YES
Printable DEL code NO
CPU Compensation Standard
Vertical Control Line Spacing 6 LPI
Form Tear-Off 500 ms (ON)
Skip Over Perforation NO
Auto LF NO
Page Length 11”
Cut Sheet Page Length 11”
Symbol Sets Character Set STANDARD
Language Set AMERICAN, SLASH 0
Serial I/F Option Parity None
Serial Data 7 or 8 Bits 8
Protocol RDY/BSY / XON/XOFF
Diagnostic Test NO
Busy Line SSD- / DTR / RTS
Baud Rate 19200 BPS / 9600 BPS
DSR Signal INVALID
DTR Signal READY ON POWER UP
Busy Time 200 ms
378 Dimensions 14
To Next Page
Loading...