A help for control panel utilization/access.
Operating principle of the control panel
C
110
Access
to level 4 - Password
C
130
Setting
and
maintenance
part
presentation
of the control panel
Access
to
parameters
and
parameters
active
depending on authorization
C
120
Summary
of screens
Complete displays list with
access
way and
associated
sheet
C
140
Purpose
of the
cycle
end
It allows an
automatic
control of the roughing time and
measure
time i. e. the end of cycle.
•
Cycle end: operator
-
Operator
stops
the cycle ( )
•
Cycle end:
automatic
-
Cycle is
stopped
automatically.
Note: if Cycle end is
automatic,
the
parameters
of roughing and
measure times
are automatic.
Activate
/
Deactivate
the
Cycle
end
Adjustment
operator
4x
C
110
Adjustment
automatic
yes
no
measure
Adjustment
Adjustment
roughing
•
Roughing
Roughing
timer
determines maximum
authorized roughing time before
the
tested
part is considered as
bad.
To consider the tested
part as bad, it is
necessary
to
activate
the
Memo
function.
Memo
function
C
550
•
Measure
If Cycle end is activated
(automatic), user
should adjust the measure
timer i.e. the cycle end.
The measure
timer
corresponds
to the time allowed for the leak
detector
to remain in
test.
When it is reached, the
measure
flashes.
1/
1
To Next Page
Loading...
